How to solve the problem of belt machine under the mouth of material blockage

When the belt machine under the mouth of the material blocking problem, the general common reasons are about three kinds. For example, the material viscosity is too large, the belt speed is too fast, the lower mouth design problems.

For these problems, we can take a series of targeted solution strategies:

1. Material: For higher humidity, viscous materials, can consider drying before conveying, or use the scraper, that is, sweeper. It can reduce the material sticky adhesive tape, thus avoiding the formation of blockage in the lower material mouth.
2. Belt speed: According to the characteristics of the material and the conveying capacity, set and adjust the running speed of the belt conveyor reasonably, make it match with the speed of the material to avoid the clogging problem caused by the flow rate is too large or too small. At the same time, consider installing speed adjusting device (frequency conversion motor, etc.) so as to adjust flexibly according to the actual situation.
3. Design problem: This requires a later re-evaluation and improvement of the shape, size and angle of the discharging opening in relation to the actual situation to ensure that the material can slide down smoothly and reduce the accumulation phenomenon.
In fact, not only the equipment itself, the belt conveyor also belongs to the long-term use of machinery, the need for regular cleaning and inspection of all parts of the belt machine accessories, location, timely removal of accumulated materials and impurities, to maintain the cleanliness and smoothness of the equipment. At the same time, pay attention to check the belt tension, pulley wear, etc., to ensure that the equipment is in good operating condition!