How to improve the conveying capacity of belt conveyor?

Want to improve the conveying capacity of the belt conveyor, then the conveyor belt is the key, the following editorial from the conveyor belt width and belt speed and so on, to share with you!
First, how to choose the bandwidth

Usually, given the same belt speed, the conveyor capacity of the belt conveyor increases with the increase in bandwidth. At the same time, the conveyor belt must have enough width, in the passage of large materials, not close to the edge of the conveyor belt, and the distance between the guide trough and the feeding trough must ensure that the material passes through smoothly without blocking.

Second, how to control the belt speed

Belt speed selection depends mainly on the nature of the material to be conveyed, as well as the required transportation capacity, and conveyor belt tension. Specifically through the following points:
1, the characteristics of the conveyed material:

In the transportation of powdery materials, should reduce the belt speed ≤ 1.0m / s, to avoid dust flying, pollution of the environment; in the transportation of large pieces of coal, coke, should also be appropriate to slow down the belt speed, the speed is too high, in the charging point and unloading point of the material is prone to the phenomenon of cracking; at the same time, in the transportation of heavy and angular materials, should be carried out in the medium-speed, because of the sharp edges of the conveyor belt may be worn out the cover layer.

2, the arrangement of the conveyor and discharge mode:

Horizontal installation of the conveyor belt speed can be high, the greater the angle of inclination, the easier the material rolls on the tape, so you should choose a lower belt speed, generally should not exceed 3.15m/s; short-distance conveying to slow down the speed; long-distance conveyor should be used with a high belt speed, which can reduce the tape tension; unloading with a trolley, due to the conveyor belt into the unloading trolley’s actual tilt angle is larger, so the belt speed should not be too high, usually not more than 3.15m/s. Usually not more than 3.15m/s.

3、 Width of conveyor belt:

When the width of the conveyor belt is smaller, the belt speed is slower, and it is more likely to occur at high speeds, serious spilling phenomenon.

Above is a small summary for you, how to improve the conveyor belt conveyor capacity of all content, and will continue to share a variety of knowledge about the belt machine Oh!