Payment & Shipping Terms:
|Type:||Cleated Belt Conveyor||Application:||Bulk Material,pellet Material|
|Product Name:||Sidewall Belt Conveyor||Feature:||Simple Operation|
Width 650mm Belt Conveying System,
Width 65CM Belt Conveying System,
Width 650mm flat belt conveyor
This Sidewal belt conveyor with corrugated cleats, in particular applied in conveying bulk material in big inclined angle, for it with corrugated shield and horizontal clapboard belt. And it can widely used in coal, metallurgy, chemical industry, light industry, petroleum, port, mechanical etc to convey all kinds of bulk materials and the piece.
The conveyor belt with corrugated rib and diaphragm plate has a conveying angle of 90 °
Low energy consumption. Due to the absence of digging resistance during loading and internal and external friction resistance of materials during operation, the total installed power is significantly reduced compared with other conveying equipment with the same conveying capacity
Convenient connection. Any length of horizontal conveying section can be set at the head and tail of the machine to facilitate connection with other equipment
The operation is stable and reliable, its reliability is almost equal to that of general belt conveyor, and the noise is low. As the conveying parts move on the roller, the noise can be ignored
The main parts can be used with the general conveyor belt, which is convenient for use and maintenance and The structure is simple.
Large conveying capacity. Because the conveyor belt has corrugated rib, its loading end face increases, and the conveying capacity is larger than that of general belt conveyor at the same inclination angle
Belt conveyors are not allowed to overload run.
Check wear condition of the belt, the damaged should be repaired.
Operators should circuit to inspect to close observe belt conveyor running. Especially,temperature rise and noise of main motor and the brake working whether they are normal; contact state of the brake and oil level, noise of gear unit and run off of belt should be noticed;temperature rise and noise of all bearings and state of all transition loads point should be noticed;
notice to see whether the hopper are blocked, working state of pulley, idler, belt cleaner, take-ups and control equipment.
Operators should make good record if any abnormal. The belt conveyor should be stoppe on emergency.
Periodic overall: Minor overall should be once every monthes besides ordinary maintenance Overhaul should be once half past year or once every year.
Contact Person: Emily